photoloading.blogg.se - Disable deep sleep mode

It’s worth noting that this is a temporary solution and a proper workaround is not yet available. Install the pending updates and reboot your device.

Go to Windows Update and click on Check for updates.

Click on the same entry again and select ‘Start’ and then select ‘Restart’.

Click on Windows Update and select ‘Stop’.

In the Services window, look for ‘Windows Update’ service.

If you’re unable to fix the sleep mode issues by tweaking your update schedule, you can also try these advance steps: Once done, you would need to reboot your computer and try the sleep mode again. One way to fix the problem is by using Windows Update’s Settings to schedule those updates and reboots and prevent the update service from running at odd hours. How to fix sleep mode issues on Windows 10 after version 2004 Now, less than a month later, the same problem with Windows 10 has reappeared, though it may not be affecting everyone.Īs we mentioned at the outset, it appears that Windows Update is a fickle beast here and you may be able to solve this problem easily by diagnosing Windows Update. To set board in deep sleep mode I try to: // Set device in deep sleep mode.The problem with sleep mode was first reported after the release of Windows 10’s May 2020 Update and it was fixed with Windows 10 KB4568831. LPC_WDT->WDMOD |= ( 0 WDMOD & 1 WDMOD &= ~(0x4) Īlthough I stop WDT_IRQn board entry in infinite loop. //LPC_WDT->WDMOD &= ~WDTOF /* clear the time-out interrupt flag */ If ( ! LPC_WDT->WDCLKSEL | ( 1 WDCLKSEL &= ~(0x11) Reload the watchdog timer with the WDTC value. Enable watchdow by writting 0xAA followed by 0x55 to WDFEED register LPC_WDT->WDMOD = 0x5 // Watch dog enabled, reset disable, watchdog cleared by software. Setup the Watchdog time operating mode in WDMOD register LPC_WDT->WDTC =TimeOut * 256 * 4 // timeout value Set the watchdog timer constant reload value I read chapter 21.1 from UM10360 about Watchdog timer and also 4.8 about power control.įor watchdog I try to wrote this : void WatchDog_Init(uint32_t TimeOut)

For some days I've been looking for an example on how to use a watchdog to wake up from deep-sleep mode but I can not find it. First of all clarify that I'm a newbie in embedded technology.